Bruised fingers

I was rushing my project and i ended up getting bruised fingers.This wire wrapping project is really irritating, the wire stripper keep stripping the wrong side of the wire! The wire was also quite weak! I wasted quite a lot of wire while rushing it,hoping that i can try out my components today.
However,since i started at 4.00 non-stop until now which is 9.00, i only managed to put on a little more then half of the whole layout.
Why am i not doing the project now?
I RAN OUT OF WIRE!!!!
Because of all the breaking and other conditions, i wasted some wires.Anyway, even if i did not waste those wires, i will not be able to complete anyway. The wire is still not enough for me to complete the project!
Holding all those thin wires on my fingers , really bruised my fingers.Now there's this sharp but bearable pain on my finger , as if i am still holding on to the wires.

I hope i did not do anything wrong, just now when i already wrapped like 10 ++ wires i found out that some was done wrongly and it is layered one over another! So I have no choice but to remove all of them and redo the whole project!

Tomorrow should be an enjoyable day in school